iSR6200 Intelligent Storage Router Installation Guide - QLogic

7–Removal and ReplacementiSR6200 Chassis Blades2. Insert the new blade into the chassis slot. Figure 7-4 shows how to push theblade straight into the chassis (1), and then seat the blade onto the chassismid-plane by pushing up the right side lever and latching it into place (2).The blade powers on and boots up.(1)(2)Figure 7-4. Inserting the New Blade into the Chassis Slot3. Reconnect all cables to the new blade.Single-Blade InstallationFor a single-blade configuration, you must save the configuration of the originalblade using the fru save command whenever the blade configuration changes.You can save the configuration of the blade on a server you can later access touse for the replacement blade. After physically replacing the blade, you can thenuse the fru restore command to restore the saved configuration to thereplacement blade. This enables the replacement blade to retain all user-configuredsettings.The following sections show how to remove and replace a failed blade in asingle-blade chassis installation:• “Removing the Failed Blade” on page 7-5• “Installing the Replacement Blade” on page 7-77-4 ISR651101-00 G