APC Symmetra RM 4–12 kVA UPS Installation Manual - APC Media

CHAPTER 4: MESSAGESPowerView Message Meaning Corrective ActionGeneralStatus(continued)Redundancy Restored.Power module redundancy loss occurredand was restored. Either additionalmodules have been installed or the loadhas been reduced.No corrective action necessary.Load is No Longer aboveAlarm Threshold.The load exceeded the load alarmthreshold. The situation has beencorrected because either the loaddecreased or the threshold wasincreased.Min Runtime restored.The system runtime dropped below theconfigured minimum runtime and wasrestored.Either additional battery modules wereinstalled, the existing battery moduleswere recharged, the load was reduced,or the threshold was raised.ModuleFailureBad Battery Module.Bad Power Module.A battery module failed and requiresreplacement.A power module failed and requiresreplacement.Refer to module replacementprocedure SYMMETRA RMINSTALLATION MANUAL.Intelligence Module isinstalled and failed.The MIM failed and requiresreplacement.Redundant IntelligenceModule is installed andfailed.The RIM failed and requiresreplacement.ThresholdAlarmLoad is above kVA alarmthreshold.The load has exceeded the userspecified load alarm threshold.Option 1: Reduce the load.Option 2: Use the PowerViewinterface to raise the alarmthreshold.Redundancy has beenlost.The UPS no longer detects redundantpower modules. Either power module(s)failed or the load increased.Option 1: If possible, installadditional power modules.Option 2: Decrease the load.Option 3: Disable theredundancy alarm by settingredundancy to zero.(Startup>Setup>Alarms>Redundancy>Zero)19