APC Symmetra RM 4–12 kVA UPS Installation Manual - APC Media

CHAPTER 3: MENU COMMANDSLogging Menu (continued)List Event GroupsMenu ItemLists the specific events in each group.FunctionPower EventsUPS Control EventsUser ActivitiesUPS Fault EventsMeasureUPS EventsClear LogClears the view log. Does not clear the active event lists.Status MenuThe Status menu displays information regarding load, battery and power modules, voltage, and electrical current.Menu ItemØ Vin Vout Iout% load assumingno redundancy% load allowing forn+ redundancyFrequenciesBattery StatusScreenPower ModuleStatus ScreenAlarm ThresholdsStatus ScreenMiscellaneousStatus ScreenFunctionDisplays input voltage, output voltage, and output current information.Compares the current load to the total capacity of all power modules.Compares the current load to the total capacity of all power modules except the power modulesthat are set aside by the “Fault Tolerance” alarm threshold. For example, if there are fourpower modules installed, and the fault tolerance alarm threshold is set to “1,” this percentage ofload uses only 3 power modules for the calculation. See Setup-Alarms to set the redundancylevel.Displays the measured input and output frequencies.Displays battery module source capacity, runtime, and status information.Displays power module source capacity, fault tolerance, and status information.Displays the user-defined alarm settings. See Setup-Alarms to set these alarm thresholds.Displays the summary result Self Test, Last System Transfer, Operating Mode, and status ofIntelligence and redundant intelligence modules.14