Owner's manual - Electric bikes & folding bikes
Owner's manual - Electric bikes & folding bikes Owner's manual - Electric bikes & folding bikes
owner's manualEnsure that the brake disk iscorrectly inserted in the brakecalliper, and the wheel rotatesfreely withoutinterference from the brakeshoes.Ensure correct replacement ofthe chain on the front and rearchain rings.Reconnect the motor powerconnectors.Cable tie both motor cables tothe frame.If you are unsure about this brake set-up andadjustment procedure, please take your A2B to your UltraMotor dealer and ask for assistance in adjusting the brakes.Improperly adjusted brakes may cause reduced brakingperformance, leading to an accident that could result inserious or fatal injury and/or property damage. DO NOTride your A2B if you are not confident that the brakes areworking properly.31
9.0 CleaningRubber and plastic parts willbe damaged by caustic orpenetrating cleaning agentsor solvents.Always carry out a brake testafter cleaning and beforestarting a ride!Do not use steam or highpressurejet devices!Such devices can damageseals, the battery and electricalsystem.- To wash the A2B, use a softsponge and clean water.- Afterwards, dry off with apolishing cloth or chamois.- Do not wipe off dust or dirtwith a dry cloth, to avoidscratching the paint orcovering.Never use paint-polishingagents on plastic parts.- After a longish ride,thoroughly clean the A2Band preserve it with acommercially availableanti-corrosion agent.Protect the environment by using only environmentallyfriendly preservation agents,and use them frugally.Use of the A2B in the winter can cause considerable damagedue to the presence of salt on the roads.Do not use hot water, which would in crease the effect ofthe salt.- At the end of each ride, wash the A2B with cold water.- Thoroughly dry the A2B.- Treat parts liable to corrosion with wax borne anticorrosionagents.32
- Page 1 and 2: BA228114
- Page 4 and 5: owner's manualContents1.0 Introduct
- Page 6 and 7: owner's manual2.0 Important informa
- Page 8 and 9: owner's manual1.2.3.4.5.6.7.8.9.10.
- Page 10 and 11: owner's manual4.0 UnpackingNOTE: Yo
- Page 12: owner's manual4.4 Installing the pe
- Page 17 and 18: Remember that there are power cut-o
- Page 19 and 20: 5.6 Luggage CarrierYour A2B equippe
- Page 21 and 22: 6.0 Battery use, storage and dispos
- Page 23 and 24: • The Indicator LED will illumina
- Page 25 and 26: Charging instructions for storageBe
- Page 27 and 28: Check your A2B before every ride.Do
- Page 29 and 30: 8.0 MaintenanceHave your A2B checke
- Page 31 and 32: 8.7 Removing and re-installing whee
- Page 33: Removing rear wheel1. Ensure that t
- Page 37 and 38: 3411.0 Technical InformationGeneral
- Page 39 and 40: 2.3.6 any modification, alteration
- Page 41: Ultra MotorUltra Motor USA 1661 Ten
9.0 CleaningRubber and plastic parts willbe damaged by caustic orpenetrating cleaning agentsor solvents.Always carry out a brake testafter cleaning and beforestarting a ride!Do not use steam or highpressurejet devices!Such devices can damageseals, the battery and electricalsystem.- To wash the A2B, use a softsponge and clean water.- Afterwards, dry off with apolishing cloth or chamois.- Do not wipe off dust or dirtwith a dry cloth, to avoidscratching the paint orcovering.Never use paint-polishingagents on plastic parts.- After a longish ride,thoroughly clean the A2Band preserve it with acommercially availableanti-corrosion agent.Protect the environment by using only environmentallyfriendly preservation agents,and use them frugally.Use of the A2B in the winter can cause considerable damagedue to the presence of salt on the roads.Do not use hot water, which would in crease the effect ofthe salt.- At the end of each ride, wash the A2B with cold water.- Thoroughly dry the A2B.- Treat parts liable to corrosion with wax borne anticorrosionagents.32