TERRA CL 08 - 33 Air - Water - Heatpump
TERRA CL 08 - 33 Air - Water - Heatpump
TERRA CL 08 - 33 Air - Water - Heatpump
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Operation<br />
The<strong>TERRA</strong>heat pump is switched on and off fully automated<br />
by the Multi talent control.<br />
For a proper operation of the controls the manual has<br />
to be looked up.<br />
An annual service and maintenance of the installation<br />
by a customer service is recommended in concern<br />
of warranty claims.<br />
Main Switch<br />
Enable Heating rod<br />
Main Switch:<br />
Switch the control circuit and the main connection for the<br />
heating rod and the compressor.<br />
Enable:<br />
Enables the heatpump<br />
Heating rod:<br />
It can be switched between different operating methods:<br />
0: the heating rod is disabled<br />
I: the heating rod runs if the two - valent condition<br />
point is below the target and there is a upon load<br />
dependent request.<br />
II: the heating rod runs if there is only a upon load<br />
dependent request.<br />
In Mode I and II the heating rod will run in case of an<br />
error.<br />
Defrost Controller Heating Controller<br />
Defrost Controller:<br />
This controller optimizes the defrost process of the heatpump<br />
and monitoring errors.<br />
Heating controller:<br />
This is the main controller for heating circuits, domestic<br />
hot water, circulation pumps and time programms.<br />
Seite 3