E-table 2 assembly directions - Coalesse

More documents

Recommendations

Info

Each C-beam will be attached to each base bracket with a total of three screws, but only two will beinstalled now.Carefully refer to the diagram on the sticker and install screws in the first and third lacations only. Themiddle screw locations will be left open for now.Repeat for both sides of each bracket, for a total of eight screws.Page 8 of 16939500448 Rev B
7. (FOR THREE OR FOUR-BASE TABLES ONLY) CONNECT JUMPER FROM ONE WIREWAY TOTHE NEXT WIREWAY(On all two-base tables, the jumpers connecting power blocks are factory-installed).On three or four-base tables, a jumper (or jumpers) must be field installed to connect the last powerblock on one beam to the first power block on the next beam.One end will be connected to the power block at the factory. Depending on the exact specifications,there are two different ways the other end may need to be connected.Depending on the configuration and length of the table the connection from one beam to the next beammay require multiple jumpers. If more than one jumper is required, they will be supplied with anH-Connector that is used to connect one jumper to another.JumperH-ConnectorH-ConnectorNext jumperconnectedto H-ConnectorFirst jumper connected to last power blockOther versions of the table only use jumper. In this case, the utility bay insert (gray steel) must beremoved to access the power block connection. Remove all the screws holding the insert to the beams.Carefully pull the insert off and make the jumper connection to the exposed block. Replace the insertand screws.Remove thisinsert to accessthe power block.Page 9 of 16939500448 Rev B
Page 1 and 2: E-table 2Keep These Instructions Fo
Page 3 and 4: Wiring SchematicHardwareFour-Circui
Page 5 and 6: 3. PULL THE POWER INFEED UP THROUGH
Page 7: 6. Attach the beams to the base bra
Page 12 and 13: 11. Install table top: two-base tab
Page 14 and 15: Insert the locking sleeves so the n
Page 16: APPENDIX A:OPTIONAL FLOOR MONUMENT

E-table 2 assembly directions - Coalesse

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?