E-table 2 assembly directions - Coalesse
E-table 2 assembly directions - Coalesse
E-table 2 assembly directions - Coalesse
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
BEFORE YOU BEGIN: Make sure you have all the <strong>table</strong> components:Table top- (1) piece <strong>table</strong> top OR- multiple piece <strong>table</strong> top. Tite-Joint Fasteners will be includedTable bases- (2) bases for <strong>table</strong>s 12' or shorter OR- (3) bases for <strong>table</strong>s from 14', up to 20' long OR- (4) bases for <strong>table</strong>s over 20’ longNOTE: UTILITY BAYS ARE SHIPPED INSIDE BASE CARTONS. Make sure all Utility Bays are located and removed before discarding thebase cartons.Wireway Assembly- (1) power infeed - There are three types: four-circuit hardwire, NYC four-circuit hardwire, or 20-amp single-circuit plug.- (1) Wireway <strong>assembly</strong> for two-base <strong>table</strong>s, OR- (2) Wireway assemblies for three-base <strong>table</strong>s OR- (3) Wireway assemblies for four-base <strong>table</strong>sEach Wireway <strong>assembly</strong> consists of:(2) black steel "C"-shaped beams, with one or more gray steel "W"-shaped inserts attached.(2) Black steel side panels. These will be shipped partially installed.(1) black plastic bottom access doorHardware- #10-24 x 1/2" Pan-Head Phillips machine screws, black. Quantity varies with <strong>table</strong> size and configuration. Vecta part #73053702- (Laminate and Veneer base <strong>table</strong>s only) #10 Type A X 1-1/4" Pan-Head Phillips wood screws, black. Quantity varies with <strong>table</strong> size andconfiguration. Vecta part #73030401- #12 Type A x 1” Pan Head Phillips wood screws, black. Quantity varies with <strong>table</strong> size and configuration. Vecta part #730430- Conduit Clamp, #10 x 3/4” wood screw, #10 x 3/4” bolt and nut`Duplex OutletsThese are ordered separately from the <strong>table</strong> but will be factory installed. Duplexes are identified with numbers corresponding to their circuits: 1through 4. On Circuit 1 duplexes will work with single circuit plug infeed.Optional- Floor Monument Cover- Flexible cord conduitTOOLS REQUIRED:- Drill driver with #2 and #3 Phillips head bits- Short (less than 6" long ) Phillips screwdriver, #2- Rubber Mallet and Nail Set (for Tite Joint Fasteners on two piece tops)NOTE REGARDING HARDWIRE POWER IN-FEEDSA LICENSED ELECTRICIAN MUST CONNECT THE POWER IN-FEED (S) TO THE BUILDING POWER SOURCE IN ACCORDANCE WITH ALL NATIONAL AND LOCALELECTRICAL CODES. THESE ELECTRICAL ASSEMBLIES ARE INTENDED FOR INSTALLATION IN ACCESSIBLE DRY LOCATIONS IN ACCORDANCE WITH ARTICLE 604OF THE NATIONAL ELECTRIC COD NFPA70. IF YOU HAVE ANY CONCERNS ABOUT A SPECIFIC APPLICATION PLEASE CONSULT THE LOCAL AUTHORITY HAVINGJURISDICTION. THIS SYSTEM IS RATED FOR A MAXIMUM OF 20 AMPS, 125/250 V, 1-PHASE, 60Hz OR 120/208 V, 3-PHASE, 60Hz.WARNING: “RISK OF FIRE OR ELECTRICAL SHOCK. DO NOT ELECTRICALLY CONNECT TO MORE THAN ONE SOURCE OF SUPPLY. ALWAYS DETERMINE THAT THEWIRING ASSEMBLY IS ELECTRICALLY CONNECTED TO ONE AND ONLY ONE SOURCE OF SUPPLY”Page 2 of 16939500448 Rev B
Change language