10.07.2015 Views

Diagnostic Trouble Code (DTC) Charts - TheDieselStop.com

Diagnostic Trouble Code (DTC) Charts - TheDieselStop.com

Diagnostic Trouble Code (DTC) Charts - TheDieselStop.com

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

6.0L Diesel <strong>Diagnostic</strong> <strong>Trouble</strong> <strong>Code</strong> (<strong>DTC</strong>) Descriptions<strong>DTC</strong> Description Possible Causes <strong>Diagnostic</strong> Aids123 — Intake Manifold The PCM will ignore the • <strong>DTC</strong> 123 can be set due <strong>DTC</strong> 123 is set by PCMAbsolute Pressure Signal MAP signal when the to a restricted or plugged when the MAP signal isIn-Range Fault signal is detected to be out sensor inlet, VREF greater than 120 kPa (2of range or an incorrect shorted to a voltage psi) absolute at low idle.value is read. The engine source greater than 5.5will continue to operatebased on estimated values.volts, or a defective MAPsensor.• When <strong>DTC</strong> 123 is activethe amber ENGINEindicator is illuminated.124 — Injection Control The PCM continuously • <strong>DTC</strong> 124 can be set due <strong>DTC</strong> 124 is set by thePressure Signal Out Of monitors the signal of the to an open or short to PCM if signal voltage isRange Low ICP sensor to determine if ground on the signal less than 0.039 volts forthe signal is within an circuit, a defective sensor more than 0.1 seconds.expected range. If the PCM or an open VREF circuitdetects a higher or lower or a VREF circuit short tovoltage than expected, the ground.PCM will set a <strong>DTC</strong>, • When <strong>DTC</strong> 124 is activeilluminate the amberthe amber ENGINEENGINE indicator, ignore indicator is illuminated.the ICP sensor signal, anduse a preset value basedon engine operatingconditions.125 — Injection Control The PCM continuously • <strong>DTC</strong> 125 can be set due <strong>DTC</strong> 125 is set by thePressure Signal Out Of monitors the signal of the to an open signal ground PCM if the signal voltage isRange High ICP sensor to determine if circuit, short to a voltage greater than 4.9 volts forthe signal is within an source on the ICP signal more than 0.1 seconds.expected range. If the PCM circuit, or a defectivedetects a higher or lower sensor.voltage than expected, the • When <strong>DTC</strong> 125 is activePCM will set a <strong>DTC</strong>,the amber ENGINEilluminate the amberindicator is illuminated.ENGINE indicator, ignorethe ICP sensor signal, anduse a preset value basedon engine operatingconditions.(Continued)2004 F650/F750 6.0L Diesel

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!