horizontal/vertical metal cutting bandsaw - Harbor Freight Tools

7.8.DON’T FORCE TOOL. It will do thejob better and safer at the rate forwhich it was designed.USE RIGHT TOOL. Don’t force toolor attachment to do a job for which itwas not designed.RECOMMENDED MINIMUM WIREGAUGE FOR EXTENSION CORDS(120 VOLT)NAMEPLATEAMPERES(at full load)9.10.11.EXTENSION CORDLENGTH25’ 50’ 100’ 150’0 – 6 18 16 16 146.1 – 10 18 16 14 1210.1 – 12 16 16 14 1212.1 – 16 14 12 Do not use.TABLE AUSE PROPER EXTENSION CORD.Make sure your extension cord isin good condition. When using anextension cord, be sure to use oneheavy enough to carry the currentyour product will draw. An undersizedcord will cause a drop in line voltageresulting in loss of power and overheating.Table A shows the correctsize to use depending on cord lengthand nameplate ampere rating. If indoubt, use the next heavier gage.The smaller the gage number, theheavier the cord.WEAR PROPER APPAREL. Do notwear loose clothing, gloves, neckties,rings, bracelets, or other jewelrywhich may get caught in movingparts. Nonslip footwear is recommended.Wear protective hair coveringto contain long hair.12.13.14.15.16.17.18.19.ALWAYS USE SAFETY GLASSES.Also use face or dust mask if cuttingoperation is dusty. Everyday eyeglassesonly have impact resistantlenses, they are NOT safety glasses.SECURE WORK. Use clamps or avise to hold work when practical. It’ssafer than using your hand and itfrees both hands to operate tool.DON’T OVERREACH. Keep properfooting and balance at all times.MAINTAIN TOOLS WITH CARE.Keep tools sharp and clean for bestand safest performance. Followinstructions for lubricating and changingaccessories.DISCONNECT TOOLS before servicing;when changing accessories,such as blades, bits, cutters, and thelike.REDUCE THE RISK OF UNINTEN-TIONAL STARTING. Make sureswitch is in off position before pluggingin.USE RECOMMENDED ACCESSO-RIES. Consult the owner’s manual forrecommended accessories. The useof improper accessories may causerisk of injury to persons.NEVER STAND ON TOOL. Seriousinjury could occur if the tool is tippedor if the cutting tool is unintentionallycontacted.CHECK DAMAGED PARTS. Beforefurther use of the tool, a guard orother part that is damaged shouldbe carefully checked to determinethat it will operate properly and performits intended function – check foralignment of moving parts, bindingof moving parts, breakage of parts,mounting, and any other conditionsthat may affect its operation. A guardSKU 93762 For technical questions, please call 1-800-444-3353. Page 4