horizontal/vertical metal cutting bandsaw - Harbor Freight Tools

MaterialTool Steel,StainlessAlloy Steels,BearingBronzeMedium to HighCarbon Steels,Hard Brass orBronzeLow to MediumCarbon Steels,Soft Brass,Aluminum,PlasticSpeed(FPM)Pulley GrooveSpindleMotor80 Large Small120 Medium Medium200 Small LargeTo Convert The Bandsaw For VerticalUse:NOTE: Notching, slitting, and contourwork is best done with the Bandsawin its vertical position.SUPPORTPLATE (150)BODYFRAME(60)LOCKINGPIN (153)2.Refer to the Chart above to determinethe proper cutting speed for aspecific type of material being cut.SPINDLE PULLEYLARGEMEDIUMSMALLFIGURE GMOTOR PULLEYSMALLMEDIUMLARGE3. The cutting speed can be adjusted byloosening the Hex Bolt (70) and movingthe Motor (81) forward. Place theV-Belt around the desired grooves inthe Spindle Pulley (1) and Motor Pulley(79). Next, move the Motor backwardsto tighten the tension on theV-Belt. Then, re-tighten the Hex Boltto secure the Motor in place.(See Figures E, F, and G.)FIGURE H1. Raise the Saw Head to its full verticalposition, making sure it locks inposition by turning the Support Plate(150) to the right until it firmly locksinto the Body Frame (60) and insertingthe Locking Pin (153).(See Figure H.)4. WARNING! Always securelyclose the Lid on the Pulley Cover(72) after installing a V-Belt (10) oradjusting the cutting speed.SKU 93762 For technical questions, please call 1-800-444-3353. Page 12