horizontal/vertical metal cutting bandsaw - Harbor Freight Tools

To Attach The Pulley Cover:WORMSHAFT (9)BODYFRAME (60)HEX BOLT (76)FLAT WASHER (77)PULLEYCOVER (72)MOTORSHAFT (81)2.Insert the Shaft Key (80) in the sloton the Motor Shaft (81). Align theslot in the Motor Pulley (79) withthe Shaft Key. Slide the Motor Pulleyfully onto the Motor Shaft. Thensecure the Motor Pulley to the MotorShaft, using one Socket Head Screw(2). (See Figure E.)To Install The V-Belt:FIGURE DPosition the Pulley Cover (72) overthe Worm Shaft (9) and Motor Shaft(81). Align the mounting hole in thePulley Cover with the mounting holein the Body Frame (60). Then securethe Pulley Cover to the Bandsaw,using one Hex Bolt (76) and one FlatWasher (77). (See Figure D.)To Attach The Spindle Pulley And MotorPulley:SPINDLE PULLEY (1)V-BELT (10)FIGURE ESHAFT KEY (80)(NOT SHOWN)MOTOR PULLEY (79)1. Slide the Spindle Pulley (1) fully ontothe Worm Shaft (9). Then secure theSpindle Pulley to the Worm Shaft,using one Socket Head Screw (2).(See Figure E.)HEX BOLT (70)FIGURE FMOTOR (81)The V-Belt (10) can be installed byloosening the Hex Bolt (70) and movingthe Motor (81) forward. Place theV-Belt around the top grooves in theSpindle Pulley (1) and Motor Pulley(79). Next, move the Motor backwardsto tighten the tension on theV-Belt. Then, re-tighten the Hex Boltto secure the Motor in place.(See Figures E and F.)To Adjust The Cutting Speed:1.The Bandsaw is designed to cut atthree different speeds: 80, 120, and200 FPM (Feet Per Minute) dependingon the type of material being cut.SKU 93762 For technical questions, please call 1-800-444-3353. Page 11