horizontal/vertical metal cutting bandsaw - Harbor Freight Tools

To Attach The Bandsaw To The Stand:To Attach The Stock Stop Assembly:MOUNTING HOLESTAND(TOP VIEW)MOUNTING HOLEMOUNTING HOLE1.When mounted to the Bandsaw, theadjustable Stock Stop assembly isused to make repetitive cuts of thesame length.HEX BOLT (149)SOCKET HEADSCREW (156)MOUNTING HOLEMOUNTING HOLESHAFT (158)STOCKSTOP (157)MOUNTING HOLESCREW (59)SPRING WASHER (58)FLAT WASHER (57)FIGURE B1. With additional manpower, and anadequate lifting device, carefully setthe Bandsaw on top of the Stand assembly,making sure the upper sectionof the Stand fits outside the baseof the Bandsaw. (See Figure B.)2. Align the three threaded mountingholes in each end at the base ofthe Bandsaw with the three mountingholes located at each end of theStand assembly. Then secure theBandsaw to the Stand assembly, usingthree Screws (59), three SpringWashers (58), and three Flat Washers(57). (See Figure B.)FIGURE CEND VIEWWITHHAND WHEEL (171)IN FOREGROUND2. To attach the Stock Stop assembly,slide the Shaft (158) into the mountinghole in the Machine Bed (142),and secure the Shaft by tighteningthe Hex Bolt (149). (See Figure C)3.Slide the Stock Stop (157) onto theShaft (158), and secure by tighteningthe Socket Head Screw (156).(See Figure C.)SKU 93762 For technical questions, please call 1-800-444-3353. Page 10