ZICM357P2 - Evaluation Kit User's Guide - California Eastern ...

ZICM357P2 - Evaluation Kit User’s GuideCLI CommandsThe following table (Table 1.) details the commands and functions which are available for use through the terminal interfacewhen the evaluation board is configured for use in CLI mode.COMMANDDESCRIPTIONCOMMANDDESCRIPTIONHELPVERSIONPrints the Help menu list of commands.Prints the firmware version number information.MFG TONE Shows how to use mfglibStartTone()and mfglibStopTone() to transmit atone over a radio.INFONETWORKNETWORK FORM NETWORK JOIN NETWORK INITNETWORK LEAVENETWORK PJOIN RESETTOKENTOKEN INITTOKEN CalibrateFLASH READ Prints various information about thedevice and device status, including appversion, network status, EUI-64 of device,mfg mode status and stack status.Prints the network help menu list of commands.Command for forming a network withchannel and power settings for a particularpanid in hexadecimal format.Command for joining a network withchannel and power settings for a particularpanid in hexadecimal format.Command for initializing a network.Command for leaving a network.Command for permitting joining a networkfor a period of time (in seconds).Resets the device.Prints list of token commandsInitializes all the mfg tokens.Calibrate the current channelCommand for reading flash contents.MFG STREAM MFG SEND test- packetMFG SEND random MFG SEND message MFG CHANNEL SET MFG CHANNEL GETMFG POWER SET MFG POWER GETLEDLED OFF LED ON Shows how to use mfglibStartStream()and mfglibStopStream() to transmit astream of random characters over a radio.Shows how to use mfglibSend() to senda packet of (length) bytes of the test-packetpayload (numPackets) times.Shows how to use mfglibSend() tosend a packet of (length) bytes of arandom payload (numPackets) times.Shows how to use mfglibSend() to sendpackets of specified payload (numPackets)times .Shows how to use mfglibSetChannel()to set the radio channel.Shows how to use mfglibGetChannel()to get the radio channel.Shows how to use mfglibSetPower()toset the radio transmit power level.Shows how to use mfglibGetPower() toget the radio transmit power level.Prints the list of LED control commands.Use led off x to turn BOARDLEDx off.Use led on x to turn BOARDLEDx on.FLASH WRITE Command for writing flash contents.LED TOGGLE CONFIGCONFIG DISPLAYUse led toggle x to toggleBOARDLEDxPrints the list of config control commands.Displays the device configurationFLASH ERASE MFGMFG START MFG ENDCommand to erase flash contents.Prints list of mfg commands.Shows how to use mfglibStart() tostart use of mfglib test functionality andpacket receive functionality. Receive handlercallback is 0 for false, 1 for true.Shows how to use mfglibStop() to end useof mfglib test functionality.CONFIG SET CONFIG SAVECURRENTCONFIG DEFAULTSENSORBUZZERDSLEEPSets the device configurationSaves current device configuration to NVRAMon the evaluation board.Sets the device configuration to defaultoneDisplays the sensor outputEnables to buzz the onboard buzzerPuts the module into deep sleep state.Table 1: CLI CommandsZICM357P2 - Evaluation Kit User’s Guide 5