ZICM357P2 - Evaluation Kit User's Guide - California Eastern ...

More documents

Recommendations

Info

ZICM357P2 - Evaluation Kit User’s GuideTable of ContentsINTRODUCTION 1RECOMMENDED DEVELOPMENT TOOLS 1TABLE OF CONTENTS 2EVALUATION APPLICATIONS 3COMMAND LINE INTERFACE (CLI) MODE 3ENTERING CLI MODE 4CLI COMMANDS 5POINT-TO-POINT (P2P) MODE 6ENTERING P2P MODE 6RANGE TEST 6PACKET ERROR RATE (PER) TEST 7DOWNLOAD FIRMWARE TO THE EVALUATION BOARDS 7INSIGHT ENVIRONMENT SETUP 8INSIGHT DESKTOP ADAPTERS VIEW 8CONNECTING THE ZICM357P2 TO THE INSIGHT ADAPTERS 8UPLOADING A FIRMWARE APPLICATION 9UPLOADING AN APPLICATION 9RELOADING AN APPLICATION 9REFERENCES & REVISION HISTORY 10ZICM357P2 - Evaluation Kit User’s Guide 2
ZICM357P2 - Evaluation Kit User’s GuideSTEPSEvaluation ApplicationsThe factory pre programmed (and certified) firmwareallows the evaluation boards to operate in two differentmodes: Command Line Interface (CLI) mode or Pointto-Point(P2P) test mode. The P2P mode allows for theboards to communicate with one another in a standaloneconfiguration (not connected to a PC), while the CLI modeis a terminal-based mode for modifying the settings andparameters of the ZICM357P2 module. The CLI mode alsoallows for the execution of simple tests for FCC validationand manufacturing tests.Command Line Interface (CLI) Mode1. Right-click on the My Computer icon on yourcomputer’s desktop, or the My Computer entry fromthe Start Menu.2. Select Properties and the System Properties windowwill be displayed.3. Click on the Hardware tab and then click on theDevice Manager button. The Device Manager will bedisplayed.4. Scroll-down and expand the Ports (COM & LPT)section. One of the items in the list of available portsshould read Silicon Labs CP210x USB to UARTBridge (COM#), where # is the assigned COM port.The screenshot shown in Figure 1 has been assignedto COM5.The CLI is a manufacturing software component of theevaluation firmware which provides the capability to testand validate the physical layer of the ZICM357P2 module.This mode can also be used in conjunction with the P2Pmode to change some of the device parameters in order tocustomize the P2P mode tests.Locating the COM Port AssignmentOnce the USB driver has been successfully installed (seethe Universal Evaluation Board User Guide) a Virtual COMport has been created. In order to interface to the terminalprogram on the PC, the COM port assignment is needed.The Windows Device Manager can be used to identify theassigned COM port, as well as verify that the drivers havebeen properly installed. To determine which COM port hasbeen assigned to the evaluation board, please follow thesteps listed above:Figure 1: CP2101 COM Port Assignment5. Make note of the assigned COM port as it will beneeded when the CEL Universal Evaluation Board with theZICM357P2 module is used with the front-end software.ZICM357P2 - Evaluation Kit User’s Guide 3
Page 1: User Guide0008-02-08-00-000 (Rev. A
Page 5 and 6: ZICM357P2 - Evaluation Kit User’s
Page 7 and 8: ZICM357P2 - Evaluation Kit User’s
Page 9: ZICM357P2 - Evaluation Kit User’s

ZICM357P2 - Evaluation Kit User's Guide - California Eastern ...

Create successful ePaper yourself

Delete template?

Save as template?