How to build a cat enclosure - City of Tea Tree Gully

More documents

Recommendations

Info

Step 1 Measure and plan the projectMeasure the required length of the 25mm tubing. The pipes will run vertically up thefence, before angling in towards the property (the angled section of the pipe should be0.7 metres long and be on an angle of at least 35 degrees). See Figures 1 & 3 forexamples. Netting at this angle is difficult for cats to climb over.The total height of the fence including the netting structure should be at least 2 metres, toprevent the cat from jumping over it (some cats can clear 1.8 metres in a single jump!).Calculate the number of supports required, and check prices with your supplier. Pipesupports need to be fitted on fence posts, corners and gates at no more than 2.8metres apart.Measure the length and width of the netting required. The netting will be affixed to theexisting fencing and to the top of the angled section of pipe.Stage 2 – PaintingBefore you start affixing the pipe supports, paint any non-galvanised steel with metalprimer and paint.Stage 3 - AffixingThe supports are fixed to the fence with saddle clips or clamps (see Figure 4).Drill a small hole in the top of each support and run a length of galvanised tie wirearound the top through these holes. Fix the netting to the top wire with metal clips.See Figure 5.The netting can be secured to the top of the fence with staples and a run of wire(see Figure 6). Staples attach the run of wire to the fence, and metal rings are used toattach the wire to the netting. Ensure the netting is secured to the fence at regularenough intervals so your cat will not be able to escape by squeezing between thefence and the netting. Alternatively, netting can be attached to the top of the fenceusing galvanised speed bracing (see Figure 7). This involves placing netting against thetop of the fence and then securing it by applying speed bracing over the top.Figure 4: Fixing support pipes
5Galvanised wireMetal clipsMetal ringsNettingGalvanisedwireStaple or bolted fixtureFigure 5: Securing the nettingFigure 6: Netting affixed to fencing with wireAppendix:Supplier of netting (note there may be othersuppliers who provide suitable prefab fittings, inaddition to the supplier listed below)*Oxley Nets20 Network DrivePort Melbourne, Victoria Australia(03) 9646 3497, Toll free: 1800 816 505www.oxleynets.com.au*The content of this Department of Primary Industries (DPI) documentis provided for information purposes only. Information published byDPI is considered to be true and correct at the time of publication.DPI gives no representation or warranty as to the qualifications orsuitability of the service providers listed, nor any representation orwarranty that there are no other persons who provide services of thistype as the list is not intended to be exhaustive.Figure 7: Netting affixed to fencing with brace
Page 1 and 2: How tobuildcatprooffencingcat enclo
Page 3: IntroductionContrary to popular bel
Page 6 and 7: Cat Proof FencingHave you considere
Page 10 and 11: Cat enclosureattached to anexisting
Page 12 and 13: Material ChecklistFirstly, draw up
Page 14 and 15: Figure 6: Fixing light meshSewnin d
Page 16 and 17: Free standingcat enclosureCats love
Page 18 and 19: If however you do not have access t
Page 20 and 21: Step 4 - InstallationIf fixing on a
Page 22 and 23: THIS PUBLICATION ISFUNDED BY YOUR C

How to build a cat enclosure - City of Tea Tree Gully

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?