Holland FW35 Repair-Rebuild Manual - Feb 2010.pdf - Transpec

Rebuild Instructions2. Slide 9/16" washer, handle spring and 17/32" washerin order over the “S” bend of the release handle(Figure 13).3. Compress spring using the 17/32" washer until cotter pinhole is exposed (Figure 13).4. Insert cotter pin into hole on the release handle, spreadcotter pin and wrap it completely around release handle(Figure 13).8. Cam Plate Installation1. Inspect cam plate for burrs. Service as necessary.2. Lubricate cam plate track and pivot hole with a waterresistant lithium base grease (Figure 14).Figure 13RELEASEHANDLEHANDLESPRINGCOTTERPIN17/32"WASHER 9/16"WASHERCOTTER PINWRAPPED AROUNDRELEASE HANDLECOTTERPIN HOLENOTE:Lubrication is not necessary for the XA-311NoLube installation.3. Install cam plate onto handle "S" bend (Figure 14).4. Position cam plate over fifth wheel top plate so that camplate attachment hole lines up with the proper casting lughole (Figure 15).5. Place a 9/16" washer between cam plate and casting lughole with rounded side of the washer facing cam plate(Figure 15).NOTE:When installing washer rounded edge of thewasher must always face cam plate.Figure 14RELEASE HANDLEATTACHMENT HOLECAM PLATECAM PLATE TRACKCASTING LUG HOLEFigure 15CAM PLATE9/16"WASHERROUNDED CORNERSFACING CAM PLATE14XL-FW290 Rev B · 02-10 · Amendments and errors reserved · © SAF-HOLLAND, Inc.