marine corps uniform regulations - US
marine corps uniform regulations - US
marine corps uniform regulations - US
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
3032<br />
3-32<br />
MARINE CORPS UNIFORM REGULATIONS<br />
a. The leather sword sling is made of black leather or approved<br />
synthetic leather in semi-gloss or high-gloss (patent) finishes. The outer<br />
side of the leather is smoothly finished. The inner side of the sling is<br />
darkened to present about the same shade as the outer side. The sword sling<br />
consists of the following parts:<br />
(1) A leather tongue, four snap fasteners, and two straps (one strap<br />
18-1/2 inches long and the other 11-3/4 inches long).<br />
(2) The hardware, which is removable to facilitate polishing, consists<br />
of the brass snap fastener with sword hook to which the tongue is attached,<br />
and two locking snap swivel fasteners attached to the ends of the straps.<br />
The tongue is attached to the brass snap fastener by inserting the rounded<br />
tip through the squared loop at the bottom of the fastener toward the back,<br />
folding the tip down and closing the four button snap fasteners.<br />
(3) The locking snap swivels are attached by inserting the tip ends of<br />
the straps through the loops of the locking swivels, folding the tip back and<br />
inserting a brass button into the two aligned holes of the strap. The tip<br />
end of the straps will be on the under side of the straps. The large face of<br />
the button will be on the outside of the strap.<br />
it.<br />
b. The sword will not be worn without the leather sword sling attached to<br />
c. The sword is worn hooked up with the hilt inclined to the rear and the<br />
sling outside the scabbard. To attach the sword and scabbard, use the<br />
following procedure:<br />
(1) The snap fastener of the leather sling is engaged in the ring of<br />
the shoulder sling or the leather frog.<br />
(2) The scabbard is held in the right hand to the left front, with the<br />
scabbard rings to the rear.<br />
(3) Engage the snap swivel of the short sling strap to the top ring on<br />
the scabbard.<br />
(4) Engage the snap swivel of the long sling strap to the bottom ring<br />
of the scabbard.<br />
(5) Turn the scabbard 180 degrees clockwise, and loop the upper<br />
scabbard ring over the prong protruding from the outside of the snap fastener<br />
of the leather sling.<br />
4. Service Sword Frog<br />
a. The service sword frog is worn when the sword is suspended from the<br />
leather service belt.<br />
b. The service frog is made of black leather or approved synthetic<br />
leather in semi-gloss or high-gloss (patent) finish. The frog has polished<br />
brass hooks to fit the 1-inch slit at stop (when folded).