SAM4s SPS-500 series programming manual.pdf

Application Upgrade/Backup from SD/USBA Note About Software Upgrades…Most software updates will be application upgrades and will be done in S Mode from SD or USB. Use thefollowing instructions to complete these upgrades. There may be rare occasions when operating system filesare updated. Operating system updates are performed from the system menu. If an operating system updateis needed, specific instructions will accompany the update files. Care must be taken so that operating systemfiles are not inadvertently downgraded. Always clear all memory after any update.This utility allows you to upgrade or back up the SPS-500 application program (a file in the sps500 foldernamed sps500) using either an SD card or USB memory stick. The application backup utility is very usefulfor field service staff when installing new registers to an existing system. Application programs MUST BETHE SAME on all registers in a network.NOTE: SD cards must be formatted as FAT 32. To avoid compatibility issues, CRS recommends that youpurchase SD cards from CRS.1. At your PC, create an “sps500” folder on SD/USB card. Copy the application image (sps500) to thisfolder.2. Insert SD card or USB memory stick into the SPS-500.3. From the S Mode main menu touch Self Test, and then touch APPLICATION UPDATE.4. Select Application Update or Application Backup.5. Select SD or USB.28 Software Installation & SD Utilities SPS-500 Program Manual v1.13