SAM4s SPS-500 series programming manual.pdf

(53) USE DEST. OPTIONIf “The Same For All Reg”, all registers will have the same settings for option #2 (Enforce Destination)and option #3 (Default Destination). If “Register Separately”, settings for options #2 and #3 will notdownload and must be programmed separately. For example, if a restaurant has both counter and drivethru service, you would select “Resister Separately” so that counter registers would prompt destinationand drive thru registers would not prompt destination entry.(54) ONLY DISPLAY SCREEN WHICH HAS PLU ON SELECT PLU PROGRAMWhen programming PLUs, the SELECT PLU screen allows you to view and select PLUs as they areplaced on keylinks. If the YES option is selected here, keylinks that do not display any PLUs are notavailable to view.(55) DISPLAY MESSAGE ON POLEA programmable 25-character message can be displayed on the standard pole display. Choose NONE,MESSAGE to display the programmable message, or TIME to display the time. Select P Mode,MESSAGES, POLE DISPLAY MESSAGE to program the message. Note: Message will display whenscreen saver is displayed.(56) POLE DISPLAY MESSAGE DIRECTIONChoose the direction you wish the pole display message to scroll: LEFT, RIGHT or BOTH to view themessage bouncing back and forth.(57) ALLOW SALES UNDER MINIMUM STOCKWhen STOCK status is assigned to a PLU (see PLU STATUS GROUP option #16), a warning “BELOWMINIMUM STOCK” will display when if the PLU is registered and stock is below the minimum level.(58) SCREEN SAVER TYPESelect FLOATING or ROTATE. Floating requires a single image, named “logo.jpg” which will float in apattern across the screen. Rotate allows multiple images to display in sequence. Up to 50 images areavailable and must be named “logo##.jpg” where ## is the image number: 01 through 50.(59) SHOW REAL TIME STOCK ON KBDIf Yes, the current stock counter will be displayed on the PLU button located on a Key Link. Stockcounters may be slightly different if the items are registered at other terminals in a network. The stockcounter is updated after the key is touched.(60) SUPPRESS SELECTIVE DISCOUNT ERROR MESSAGEIf selective discount (coupon search) is used, an error will result if a discount is attempted for an item thatis not registered in the transaction. You can suppress that error message here. (To set up selectivediscounts, see “Promotion Table” on page 150 and also see the “"%” Key Program Note” on page 99.)(61) PRINT POWER FAIL COUNT WHEN POWER FAIL OCCURSEach time the register powers on it will print a chit to the programmed receipt printer stating there was apower fail with the time, date, register number. For example:POWER FAIL!!TIME: 16:53 DATE : 7/10/2009POWER FAIL COUNT : 2Also added a way to reset this count. In REG mode press [X/TIME]; the number of POWER FAILSdisplays and the user can press [RESET] to set number of power fails to 0. The manager password willbe needed to reset the power fail count.106 P Mode Programming SPS-500 Program Manual v1.13