SAM4s SPS-500 series programming manual.pdf

(42) BASE CURRENCYSet for local currency.(43) ALLOW CLERK INTERRUPTIf allowed, a new clerk can be signed on in the middle of a transaction. In this circumstance, the initialtransaction is suspended. When the interrupt transaction is completed, the suspended transaction can becontinued. You must set option #45 in this program, “ALLOW CLERK CHANGE WITHOUT SIGN-OFF” to YES and set the S Mode System Option, “REG# HOLDS CLERK INTERRUPT DATA” toactivate this feature.CAUTION: If used, this feature may cause operator confusion. Suspended transactions may appear to“disappear”, when in fact; the original clerk must sign on to recall the suspended transaction.(44) ALLOW FLOATING CLERKWith ‘NO’ of this option, the employee must reopen his or her interrupted order on the register whichhe/she used before. If you set to YES, employee is allowed to open interrupted order at any register.(45) ALLOW CLERK CHANGE WITHOUT SIGN-OFFIf YES, new clerk sign on is allowed without previously signing off the current employee. Must be set toYES if clerk interrupt is implemented.(46) SKIP IN NOT FOUND PLU REGISTRATIONGROUP LINK #1DESCRIPTORThe “Not Found PLU” sequence asks for LINK STATUS and LINK GROUP. Select here if you wish tobypass these entries.(47) RECEIPT STATUS ON OPERATOR DISPLAYChoose Yes to display the receipt on/off status on the operator display. Receipt-on displays as "Ron";receipt-off displays as "ROff".(48) CARD READER ENABLERequired for use of employee cards.(49) ALLOW SALES FOR 0 STOCK ITEMSIf Yes, sale of items with zero stock is allowed.(50) DATE OF BIRTH ENTRY COMPULSORYIf Yes, date of birth for age verification items must be entered at prompt. Operator may press escape tosell items when set to N.(51) CHECK DIGIT IS SENT FROM BCRSetting needs to match your scanner setting. If scanner is set to read check digit, this option must be Yes.(52) DISPLAY POPUP ON DESTINATION CHANGEIf YES, a pop-up window will display when a destination key (EAT-IN, TAKE OUT, DRIVE THRU) ispressed.SPS-500 Program Manual v1.13 P Mode Programming 105