Service Instructions

More documents

Recommendations

Info

Service Instructions BZFM Stromag DessauIP 54safety in motionElectromagnetic Double - Face Spring-Applied Brake 12.12.20067. MaintenanceMake shure to comply with chapt. 1 “Safety guidelines” during all maintenance andinspection work.As the brakes work under varying operation conditions, it is not possible to pre-define wear check,inspection maintenance and repair intervals.Higher loads on the brakes (e.g. as a result of torque, speed, switching frequency, ambienttemperature etc.) require shorter maintenance intervals.Therefore it is first of all necessary to observe the brake with regard to safety and wear, and thenadapt the maintenance intervals in accordance with the observation made.Wear of the friction lining will result as a greater air gap “off”Depending on the load of the brake, the air gap must be checked from time to time. This will be doneby measuring of the air gap according to chapter 4.1.3.If the max. airgap as determined in chap. 2 (table 1) is reached please readjust the airgap describedin chap. 4.3.Caution!If the wear re-adjustment is not carried out early enough, both the transmission of the rated loadtorque and the lifting of the brake will not be ensured.8. Spare parts stocking, after sales-service8.1. After-sales serviceStocking of spare and parts subject to wear is an important precondition for permanet an reliablefunctioning of the brake.friction lining carrier (04), friction lining (05) and armature disc (02), (for item see chapter 3.1.) areparts subject to wear.Warranty will be provided only for the original spare parts supplied by us. We expressly state that theinstallation or use of spare parts other than the original ones supplied by us will negatively affect thedesign characteristics of the brake and thus have an impact on active and/or passive safety.Stromag Dessau GmbH shall have no warranty obligations for any damage caused by the use ofspare parts or accessories other than the original ones supplied by us.Please bear in mind that often particular manufacturing and delivery specifications exist for partsmanufactured by us or bought from others, and that we offer spare parts to the up-dated technicalconditions and the up-dated legal prescriptions.17
Service Instructions BZFM Stromag DessauIP 54safety in motionElectromagnetic Double - Face Spring-Applied Brake 12.12.20068.2. Data for the ordering of spare partsPlease specify the following details when ordering spare parts:- Series and size of brake- Consignment / fabrication number- Location and designation of spare part- Number of piecesDesignation of individual parts01 Coil body02 Armature disc03 N-side end plate04 friction lining carrier05 Friction lining06 Coil07 Compression spring08 Spring bolt09 Adjusting screw10 Cyl. screw11 Mounting screw12 Adjusting ring13 sealing ring14 rubber collar15 identification plate16 microswitch17 distance bolt18 hexagon nut40 stirrup for manual release41 hexagon head screw42 self-locking nut or castel nut43 washer44 compression spring45 lever for mechanical release46 rubber plate48 straight grooved pin49 grooved drive stud18
Page 2 and 3: Service Instructions BZFM Stromag D
Page 14: Service Instructions BZFM Stromag D
Page 17: Service Instructions BZFM Stromag D

Service Instructions

Create successful ePaper yourself

Delete template?

Save as template?