Catalyst 3560-E Switch Getting Started Guide - Cisco

More documents

Recommendations

Info

Before Attaching the BracketsTo install the switch in a rack, you must first remove the screws from the switch chassis so that themounting brackets can be attached. For attachment at the front-mounting position remove twoPhillips truss-head screws from the switch side panels. For some switch models, remove only one screwfrom the side panels. For attachment at the mid-mounting position, remove one screw. For attachmentat the rear-mounting position, remove one or two screws depending on the switch model.41 42 43 44 45 46 47 4820005347X49X2-150X2-248XCatalyst 3560-E SERIES PoE-48515214
10-5 A50-60 HZAC OK PS OKAttaching the BracketsUse four number-8 Phillips flat-head screws to attach the long side of each bracket to the switch in oneof three mounting positions.1141 42 43 44 45 46 47 4847X49X2-150X2-2Catalyst 3560-E SERIES PoE-4848X522513341 42 43 44 45 46 47 4847X49X2-150X2-2Catalyst 3560-E SERIES PoE-4848X5225144100-240 V20005421 Front-mounting position 3 Mid-mounting position2 Number-8 Phillips flat-head screws 4 Rear-mounting position15
Page 1 and 2: GETTING STARTED GUIDECatalyst 3560-
Page 3 and 4: SYSTRPSMASTRSTATDUPLXSP EDSTACKPoEM
Page 7 and 8: Step 15Step 16(Optional) You can en
Page 9 and 10: Refreshing the PC IP AddressAfter y
Page 11 and 12: Other Management OptionsYou can use
Page 13: WarningTo prevent bodily injury whe
Page 17 and 18: 6 Connecting to the Switch PortsThi
Page 19 and 20: Install SFP Modules and Connect to
Page 21 and 22: Resetting the SwitchThis section de
Page 23 and 24: 9 Cisco Warranty TermsCatalyst 3560

Catalyst 3560-E Switch Getting Started Guide - Cisco

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?