QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

A8 – RADIUS Server ConfigurationConfiguring a RADIUS Server on the SwitchConfiguring a RADIUS Server on the SwitchEnter the Set Setup Radius command to configure a RADIUS server on the I/Omodule. There are two groups of RADIUS configuration parameters. One group ofparameters is common to all RADIUS server configurations. The second group isserver specific. You can configure both groups of parameters for all RADIUSservers, or you can configure the common and server-specific parametersseparately. Refer to Table 12-17 for a description of the RADIUS serverconfiguration parameters.The following example configures the common RADIUS server configurationparameters:QLogic8GbT (admin) #> set setup radius commonA list of attributes with formatting and current values will follow.Enter a new value or simply press the ENTER key to accept the current value.If you wish to terminate this process before reaching the end of the attributesfor the server being processed, press 'q' or 'Q' and the ENTER key to do so.If you wish to terminate the configuration process completely, press 'qq' or'QQ' and the ENTER key to so do.PLEASE NOTE:-----------* SSL must be enabled in order to configure RADIUS User AuthenticationSSL can be enabled using the 'set setup services' command.Current Values:DeviceAuthOrder LocalUserAuthOrder LocalTotalServers 1New Value (press ENTER to not specify value, 'q' to quit):DeviceAuthOrder 1=Local, 2=Radius, 3=RadiusLocal :UserAuthOrder 1=Local, 2=Radius, 3=RadiusLocal :TotalServers decimal value, 0-5 :Do you want to save and activate this radius setup? (y/n): [n]59245-01 A 8-3