QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

6 – Port ConfigurationMapping Transparent Fabric PortsSThe following example creates a primary map and a backup map. This exampleassumes that ports 0, 15, 16, 17, 18, and 19 have already been configured asTF_Ports.• Primary map: TF_Ports 0, 15, 16 are mapped to all TH_Ports• Backup map: TF_Ports 17, 18, and 19 are mapped to all TH_PortsQLogic8GbT #> admin startQLogic8GbT (admin) config editQLogic8GbT (admin) #> set config ports internalA list of attributes with formatting and current values for the portnumber or port type specified at the command line will follow.Each value that is changed will be set for ALL INTERNAL PORTS.If you wish to terminate this process before reaching the end of thelist press 'q' or 'Q' and the ENTER key to do so.Configuring all internal ports (displaying values from port number: 1)-------------------------------------------------------------------AdminState (1=Online, 2=Offline, 3=Diagnostics, 4=Down) [Online]LinkSpeed (2=2Gb/s, 4=4Gb/s, A=Auto) [2 ]PrimaryTFPortMap (decimal value for port, N=no mapping) [0 ] 0,15,16BackupTFPortMap (decimal value for port, N=no mapping) [15 ] 17,18,19Finished configuring attributes.This configuration must be saved (see config save command) andactivated (see config activate command) before it can take effect.To discard this configuration use the config cancel command..QLogic8GbT (admin-config)#> config saveQLogic8GbT (admin)#> config activateQLogic8GbT (admin)#> admin end6-12 59245-01 A