QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

6 – Port ConfigurationModifying Port Operating CharacteristicsSModifying Port Operating CharacteristicsYou can make permanent or temporary changes to port operating characteristics.You make permanent port configuration changes using the Set Config Portcommand. These changes are saved in the active configuration and arepreserved across I/O module or port resets. The Set Port command makestemporary changes that apply until the next port or I/O module reset, or until youactivate a configuration.NOTE:8-Gbps SFPs do not support the 1-Gbps setting. Setting a port to 1-Gbpsthat has an 8-Gbps SFP will down the port.The following example permanently changes the administrative state for externalport 0:QLogic8GbT #> admin startQLogic8GbT (admin) #> config editQLogic8GbT (admin-config) #> set config port 0A list of attributes with formatting and current values will follow.Enter a new value or simply press the ENTER key to accept the current value.If you wish to terminate this process before reaching the end of the listpress 'q' or 'Q' and the ENTER key to do so.Configuring Port Number: 0------------------------AdminState (1=Online, 2=Offline, 3=Diagnostics, 4=Down) [Online] offlineLinkSpeed (1=1Gb/s, 2=2Gb/s, 4=4Gb/s, 8=8Gb/s, A=Auto) [Auto ]PortType (TH / TF) [TF ]SymPortName (string, max=32 chars) [Port0 ]Finished configuring attributes.This configuration must be saved (see config save command) andactivated (see config activate command) before it can take effect.To discard this configuration use the config cancel command.QLogic8GbT (admin-config) #> config saveQLogic8GbT (admin-config) #> config activate6-8 59245-01 A