QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

5 – I/O Module ConfigurationInstalling FirmwareSOne-Step Firmware InstallationThe Firmware Install and Image Install commands download the firmware imagefile from an FTP or TFTP server to the I/O module, unpacks the image file, andperforms a disruptive activation in one step. The one-step installation processprompts you to enter the following:• The file transfer protocol (FTP or TFTP)• IP address of the remote host• An account name and password on the remote host (FTP only)• Pathname for the firmware image file1. Enter the following commands to download the firmware from a remote hostto the I/O module, install the firmware, then reset the I/O module to activatethe firmware.QLogic8GbT #> admin startQLogic8GbT #> firmware installThe switch will be reset. This process will cause adisruption to I/O traffic.Continuing with this action will terminate all managementsessions,including any Telnet sessions. When the firmwareactivation is complete, you may log in to the switch again.Do you want to continue? [y/n]: yPress 'q' and the ENTER key to abort this command.2. Enter your choice for the file transfer protocol with which to download thefirmware image file. FTP requires an user account and a password; TFTPdoes not.FTP or TFTP: ftp3. Enter your account name on the remote host (FTP only) and the IP addressof the remote host. When prompted for the source file name, enter the pathfor the firmware image file.User Account : johndoeIP Address : 10.0.0.254Source Filename : 7.10.0.xx_epcAbout to install image. Do you want to continue? [y/n] y5-18 59245-01 A