QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

A5 – I/O Module ConfigurationResetting an I/O ModuleTo configure the I/O module to use an NTP server, enter the Set Setup SystemNtp command in an Admin session to enable the NTP client on the I/O moduleand to specify the NTP server IP address, as shown in the following example:QLogic8GbT (admin) #> set setup system ntpA list of attributes with formatting and current values will follow.Enter a new value or simply press the ENTER key to accept the current value.If you wish to terminate this process before reaching the end of the listpress 'q' or 'Q' and the ENTER key to do so.Current Values:NTPClientEnabled FalseNTPServerDiscovery StaticNTPServerAddress 10.20.10.10New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):NTPClientEnabled (True / False) : TrueNTPServerDiscovery (1=Static, 2=Dhcp, 3=Dhcpv6) :NTPServerAddress (hostname, IPv4, or IPv6 Address) : 10.20.3.4Do you want to save and activate this system setup? (y/n): [n] yResetting an I/O ModuleTable 5-2 describes the methods for resetting an I/O module, the correspondingcommand, and the impact on the I/O module.Table 5-2. I/O Module Reset MethodsDescriptionHot Reset(Hotresetcommand)Soft Reset(ResetSwitchcommand)Hard Reset(HardresetSwitchcommand)Activates pending firmware ✔ ✔ ✔Disrupts I/O traffic ✔ ✔Enterprise Fabric Suite 2007 andQuickTools sessions reconnectafterwards✔ ✔ ✔Clears the event log ✔ ✔ ✔Closes all management sessions ✔ ✔ ✔Power-on self test✔59245-01 A 5-15