QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

A5 – I/O Module ConfigurationManaging I/O Module ConfigurationsRestoring the Configuration FileThe restore operation begins with FTP to upload the configuration file from theworkstation to the I/O module, then finishes with a Telnet session and the ConfigRestore command. To upload the configuration file, config_switch_169_10112003in this case, open and FTP session with account name images and passwordimages. Transfer the file in binary mode with the Put command as shown:ftp ip_addressuser: imagespassword: imagesftp> binftp> put config_switch_169_10112003 configdataLocal file config_switch_169_10112003Remote file configdataftp>quitThe restore process replaces all configuration information on the I/O module andafterwards the I/O module is automatically reset. To restore the I/O module, opena Telnet session, then enter the Config Restore command from within an Adminsession as shown:QLogic8GbT #> admin startQLogic8GbT (admin) #> config restoreThe switch will be reset after restoring the configuration.Please confirm (y/n): [n] yAlarm Msg: [day month date time year][A1005.0021][SM][Configuration is beingrestored - this could take several minutes]Alarm Msg: [day month date time year][A1000.000A][SM][The switch will be reset in3 seconds due to a config restore]QLogic8GbT (admin) #>Alarm Msg: [day month date time year][A1000.0005][SM][The switch is being reset]59245-01 A 5-13