QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

4 – Network and Fabric ConfigurationManaging IP SecuritySModifying a User-Defined PolicyTo modify an existing user-defined policy, enter the Ipsec Policy Edit command inan Admin session and an Ipsec Edit session as shown in the following example.An asterisk (*) indicates a required entry.QLogic8GbT (admin-ipsec) #> ipsec policy edit h2h-sh-spA list of attributes with formatting and current values will follow.Enter a new value or simply press the ENTER key to accept the current value.To remove a value for an optional attribute, use ’n’.If you wish to terminate this process before reaching the end of the listpress 'q' or 'Q' and the ENTER key to do so.Current Values:Description...espRuleLevelHost-to-host: switch->hostrequireNew Value (press ENTER to not specify value, 'q' to quit, 'n' for none):Description (string value, 0-127 bytes) :*SourceAddress (IPv4, IPv6 or hostname/[PrefixLength]) :SourcePort (decimal value, 1-65535) :*DestinationAddress (IPv4, IPv6 or hostname/[PrefixLength]) :DestinationPort (decimal value, 1-65535) :*Protocol (decimal value, or keyword)Allowed keywordsicmp, icmp6, ip4, tcp, udp or any: tcp*Direction (1=in, 2=out) :Priority (value, -2147483647 to +2147483647) :*Action (1=discard, 2=none, 3=ipsec) :*ProtectionDesired (select one, transport-mode only)1=ah Authentication Header2=esp Encapsulating Security Payload3=both :*ahRuleLevel (1=default, 2=use, 3=require) :*espRuleLevel (1=default, 2=use, 3=require) :The security policy has been edited.This configuration must be saved with the 'ipsec save' commandbefore it can take effect, or to discard this configurationuse the 'ipsec cancel' command.QLogic8GbT (admin-ipsec) #> ipsec saveThe IPsec configuration will be saved and activated.Please confirm (y/n): [n] y4-12 59245-01 A