QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

4 – Network and Fabric ConfigurationManaging IP SecuritySCreating a PolicyTo create a policy, enter the Ipsec Policy Create command as shown in thefollowing exampleQLogic8GbT #> admin startQLogic8GbT (admin) #> ipsec editQLogic8GbT (admin-ipsec) #> ipsec policy create h2h-sh-spA list of attributes with formatting will follow.Enter a value or simply press the ENTER key to skip specifying a value.If you wish to terminate this process before reaching the end of the listpress 'q' or 'Q' and the ENTER key to do so.Required attributes are preceded by an asterisk.Value (press ENTER to not specify value, 'q' to quit):Description (string value, 0-127 bytes) : Host-to-host: switch->host*SourceAddress (hostname, IPv4, or IPv6 Address/[PrefixLength]): fe80::2c0:ddff:fe03:d4c1SourcePort (decimal value, 1-65535) :*DestinationAddress (hostname, IPv4, or IPv6 Address/[PrefixLength]): fe80::250:daff:feb7:9d02DestinationPort (decimal value, 1-65535) :*Protocol(decimal value, or keyword)Allowed keywordsicmp, icmp6, ip4, tcp, udp or any: any*Direction (1=in, 2=out) : 2Priority (value, -2147483647 to +214783647) :*Action (1=discard, 2=none, 3=ipsec) : 3*ProtectionDesired (select one, transport-mode only)1=ah Authentication Header2=esp Encapsulating Security Payload3=both : 2*espRuleLevel (1=default, 2=use, 3=require) : 3The security policy has been created.This configuration must be saved with the 'ipsec save' commandbefore it can take effect, or to discard this configurationuse the 'ipsec cancel' command.4-10 59245-01 A