QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

4 – Network and Fabric ConfigurationDisplaying the Ethernet Network ConfigurationSDisplaying the Ethernet Network ConfigurationThe Show Setup System command displays the entire switch networkconfiguration, which includes the following:• IP configurations• DNS server configurationTo display specific information, add the corresponding keyword. For example, todisplay DNS configuration information, enter the Show Setup System DNScommand. The following example displays the entire network:QLogic8GbT #> show setup systemSystem Information------------------Eth0NetworkDiscovery StaticEth0NetworkAddress 192.168.70.129Eth0NetworkMask 255.255.252.0Eth0GatewayAddress 0.0.0.0AdminTimeout 30InactivityTimeout 0LocalLogEnabledTrueRemoteLogEnabledFalseRemoteLogHostAddress 10.0.0.254NTPClientEnabledTrueNTPServerAddress 51.68.85.102EmbeddedGUIEnabled TrueVerifying an I/O Module in the NetworkYou can verify that an I/O module is communicating in the network using the Pingcommand. The following example successfully tests the network for an I/Omodule with IP address 10.20.11.57.QLogic8GbT #> ping 10.20.11.57Ping command issued. Waiting for response...QLogic8GbT #>Response successfully received from 10.20.11.57.If the I/O module was unreachable, you would see the following display.QLogic8GbT #> ping 10.20.11.57Ping command issued. Waiting for response...No response from 10.20.11.57. Unreachable.4-4 59245-01 A