QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

12 – Command ReferenceTest SwitchSNotesTable 12-34 describes the switch test parameters.Table 12-34. Switch Test ParametersParameterDescriptionLoopCount Number of frames sent: 1–4294967295.The default is 100.FrameSizeDataPatternStopOnErrorLoopForeverNumber of bytes in each test frame:40–2148. The default is 256.32-bit hexadecimal test value, or default,which defines random dataStops the test when an error occurs (True).Otherwise, the test continues to completion.Restarts the test after completion and continuesuntil you cancel it (True). Otherwise,the test ends normally after completion.To cancel a switch test in progress, enter the Test Cancel Switch command.To display the status of a recent switch test or switch test in progress, enter theTest Status Switch command.ExamplesThe following example performs an offline internal test on a switch:QLogic8GbT #> admin startQLogic8GbT (admin) #>set switch state diagnosticsQLogic8GbT (admin) #> test switch offline internalA list of attributes with formatting and current values will follow. Enter a newvalue or simply press the ENTER key to accept the default value. If you wish toterminate this process before reaching the end of the list press 'q' or 'Q' and theENTER key to do so.LoopCount (decimal value, 1-4294967295) [100 ]FrameSize (decimal value, 40-2148) [256 ]DataPattern (32-bit hex value or 'Default') [Default]StopOnError (True / False) [True ]LoopForever (True / False) [False ]Do you want to start the test? (y/n) [n] y12-164 59245-01 A