QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

12 – Command ReferenceShow PortSTable 12-29. Show Port Parameters (Continued)EntryClassXTossConfigTypeDecodeErrorDiagFaultCodeDiagStatusEpConnectsEpConnStateEpIsoReasonFBusyFlowerrorsFRejectInvalidCRCInvalidDestAddrLink FailuresLinkSpeedLinkStateLIP_AL_PD_ALPSLIP_F7_AL_PSNumber of times an SOFi3 or SOFn3 frame is tossed fromTBUF.Configured port typeNumber of decode errors detectedFault code from the most recent Power-on self testStatus from the most recent Power-on self testNot applicableNot applicableNot applicableNumber of times the I/O module sent a F_BSY because Class2 frame could not be delivered within ED_TOV time. Numberof class 2 and class 3 fabric busy (F_BSY) frames generatedby this port in response to incoming frames. This usually indicatesa busy condition on the fabric or N_Port that is preventingdelivery of this frame.Number of frames received there were no available credits.Number of frames from devices that were rejected.Invalid CRC detected.Invalid destination address detected.Number of optical link failures detected by this port. A link failureis a loss of synchronization or a loss of signal while not inthe offline state. A loss of signal causes the I/O module toattempt to re-establish the link. If the link is not re-established,a link failure is counted. A link reset is performed after a linkfailure.Port transmission speedPort activity statusDescriptionNumber of F7, AL_PS LIPs, or AL_PD (vendor specific)resets, performed.This LIP is used to reinitialize the loop. An L_Port, identified byAL_PS, may have noticed a performance degradation and istrying to restore the loop.12-132 59245-01 A