QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

12 – Command ReferenceSet Setup SystemSThe following is an example of the Set Setup System Logging command:QLogic8GbT (admin) #> set setup system loggingA list of attributes with formatting and current values will follow.Enter a new value or simply press the ENTER key to accept the current value.If you wish to terminate this process before reaching the end of the listpress 'q' or 'Q' and the ENTER key to do so.Current Values:LocalLogEnabledTrueRemoteLogEnabled FalseRemoteLogHostAddress 10.0.0.254New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):LocalLogEnabled (True / False) :RemoteLogEnabled (True / False) :RemoteLogHostAddress (hostname, IPv4, or IPv6 Address) :Do you want to save and activate this system setup? (y/n): [n]The following is an example of the Set Setup System Ntp command:QLogic8GbT (admin) #> set setup system ntpA list of attributes with formatting and current values will follow.Enter a new value or simply press the ENTER key to accept the current value.If you wish to terminate this process before reaching the end of the listpress 'q' or 'Q' and the ENTER key to do so.Current Values:NTPClientEnabled FalseNTPServerDiscovery StaticNTPServerAddress 10.20.10.10New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):NTPClientEnabled (True / False) :NTPServerDiscovery (1=Static, 2=Dhcp, 3=Dhcpv6) :NTPServerAddress (hostname, IPv4, or IPv6 Address) :Do you want to save and activate this system setup? (y/n): [n]12-100 59245-01 A