QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

12 – Command ReferenceSet Setup SystemStimersPrompts you in a line-by-line fashion to change the timer configuration parametersdescribed in Table 12-25. To configure all system parameters, omit the keyword.For each parameter, enter a new value or press the Enter key to accept thecurrent value.Table 12-25. Timer Configuration ParametersParameterAdminTimeoutInactivityTimeoutDescriptionAmount of time in minutes the switch waits before terminatingan idle Admin session. Zero (0) disables the timeout threshold. The default is 30, the maximum is 1440.Amount of time in minutes the switch waits before terminatingan idle Telnet command line interface session.Zero (0) disables the time out threshold. The default is 10,the maximum is 1440.12-98 59245-01 A