QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

A12 – Command ReferenceSet Setup SNMPTable 12-20. SNMP Common Configuration Settings (Continued)EntryTrapCommunityAuthFailureTrapProxyEnabledSNMPv3EnabledDescriptionTrap community password that authorizes an SNMP agent toreceive traps. This is a write-only field. The value on the I/Omodule and the SNMP management server must be the same.The trap community password can be up to 32 charactersexcluding #, semicolon (;), and comma (,). The default is “public”.Enables (True) or disables (False) the generation of traps inresponse to trap authentication failures. The default is False.Enables (True) or disables (False) SNMP communication withother switches in the fabric. The default is True.Enables (True) or disables (False) SNMP version 3. Thedefault is False.trap [trap_number]Prompts you in a line-by-line fashion to change SNMP trap parameters for the trapnumber given by [trap_number]. [trap_number] can be 1–5. For each parameter,enter a new value or press the Enter key to accept the current value. To configurecommon parameters and trap parameters, omit the Trap keyword. Table 12-20describes the common SNMP configuration parameters. Table 12-21 describesthe SNMP trap settings.Table 12-21. SNMP Trap Configuration SettingsParameterTrap [1-5] AddressTrap [1-5] PortTrap [1-5] SeverityTrap [1-5] VersionTrap [1-5] EnabledDescriptionWorkstation IP address or DNS host name to which SNMPtraps are sent. The default address for trap 1 is 10.0.0.254. Thedefault address for traps 2–5 is 0.0.0.0. Addresses, other than0.0.0.0, for all traps must be unique.Workstation port to which SNMP traps are sent. Valid workstationport numbers are 1–65535. The default is 162.Severity level to use when monitoring trap events. The defaultis Warning.SNMP version (1 or 2) to use in formatting the trap. The defaultis 2.Enables (True) or disables (False) the SNMP trap.59245-01 A 12-93