QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

12 – Command ReferenceSet Setup SNMPSSet Setup SNMPConfigures SNMP on the I/O module.AuthoritySyntaxKeywordsAdmin sessionset setup snmpcommontrap [trap_number]commonPrompts you in a line-by-line fashion to change SNMP configuration parametersthat are common for all traps. For each parameter, enter a new value or press theEnter key to accept the current value. To configure common parameters and trapparameters, omit the Common keyword. Refer to Table 12-21 for a description ofthe SNMP trap settings. Table 12-20 describes the common SNMP configurationparameters.Table 12-20. SNMP Common Configuration SettingsEntrySNMPEnabledContactLocationReadCommunityWriteCommunityDescriptionEnables (True) or disables (False) SNMP on the I/O module.The default is True.Specifies the name of the person to be contacted to respond totrap events. The name can be up to 64 characters excluding #,semicolon (;), and comma (,). The default is undefined. Thisvalue is also passed to the Call Home service configurationSpecifies the name of the I/O module location. The name canbe up to 64 characters excluding #, semicolon (;), and comma(,). The default is undefined. This value is also passed to theCall Home service configurationRead community password that authorizes an SNMP agent toread information from the I/O module. This is a write-only field.The value on the I/O module and the SNMP managementserver must be the same. The read community password canbe up to 32 characters excluding #, semicolon (;), and comma(,). The default is “public”.Write community password that authorizes an SNMP agent towrite information to the I/O module. This is a write-only field.The value on the I/O module and the SNMP managementserver must be the same. The write community password canbe up to 32 characters excluding #, semicolon (;), and comma(,). The default is “private”.12-92 59245-01 A