QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

12 – Command ReferenceSet Setup RadiusSserver [server_number]Prompts you in a line-by-line fashion to configure parameters for the RADIUSserver given by [server_number]. [server_number] is a positive integer. Toconfigure common and specific RADIUS server parameters, omit the keyword.Table 12-18 describes the specific RADIUS server configuration parameters.Table 12-18. Specific RADIUS Server Configuration ParametersParameterServerIPAddressServerUDPPortDeviceAuthServerUserAuthServerAccountingServerTimeoutRetriesSignPacketsSecretDescriptionIP address or DNS host name of the RADIUS server. Thedefault is 10.0.0.1.User Datagram Protocol (UDP) port number on the RADIUSserver. The default is 1812.Enable (True) or disable (False) this server for device authentication.The default is False.Enable (True) or disable (False) this server for user accountauthentication. A user authentication RADIUS server requires asecure management connection (SSL). The default is True.Enable (True) or disable (False) this server for auditing of activityduring a user session. When enabled, user activity is auditedwhether UserAuthServer is enabled or not.The default is False.The accounting server UDP port number is the ServerUDPPortvalue plus 1. The default is 1813.Number of seconds to wait to receive a response from theRADIUS server before timing out. The default is 2.Number of retries after the first attempt to establish communicationwith the RADIUS server fails. The default is 0.Enable (True) or disable (False) the use of sign packets to protectthe RADIUS server packet integrity. The default is False.22-byte ASCII string used as a password for authentication purposesbetween the switch and the RADIUS server.12-86 59245-01 A