QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

12 – Command ReferenceSet Setup RadiusSSet Setup RadiusConfigures RADIUS servers on the I/O module.AuthoritySyntaxKeywordsAdmin sessionset setup radiuscommonserver [server_number]commonPrompts you in a line-by-line fashion to configure parameters that are common toall RADIUS servers. To configure common and specific RADIUS serverparameters, omit the keyword. Table 12-17 describes the common RADIUSconfiguration parameters.Table 12-17. Common RADIUS Configuration ParametersEntryDeviceAuthOrderUserAuthOrderTotalServersDescriptionNot applicable to the Pass-thru Module.Authenticator priority for user accounts:• Local: Authenticate users using only the local security database.This is the default.• Radius: Authenticate users using only the security databaseon the RADIUS server.• RadiusLocal: Authenticate users using the RADIUS serversecurity database first. If the RADIUS server is unavailable,then use the local I/O module security database.Number of RADIUS servers to configure during this session.Setting TotalServers to 0 disables all RADIUS authentication.The default is 0.ServerIPAddress IP address of the RADIUS server. The default is 10.0.0.1.ServerUDPPortDeviceAuthServerUserAuthServerUser Datagram Protocol (UDP) port number on the RADIUSserver. The default is 1812.Enable (True) or disable (False) this server for device authentication.The default is False.Enable (True) or disable (False) this server for user accountauthentication. A user authentication RADIUS server requires asecure management connection (SSL). The default is True.12-84 59245-01 A