QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

A12 – Command ReferenceSet PortSet PortSets port state and speed for the specified port temporarily until the next I/Omodule reset or new configuration activation. This command also clears portcounters. For information about port numbering and mapping, see Table A-1.NOTE:For external ports (0, 15, 16, 17, 18, 19), all port parameters apply. Forinternal ports (1–14), only the port state setting is configurable.AuthoritySyntaxKeywordsAdmin sessionset port clearorset port [port_number]bypass [alpa]clearenablespeed [transmission_speed]state [state][port_number]Specifies the port. Ports are numbered beginning with 0. For information aboutport numbering and mapping, see Appendix A.bypass [alpa]Sends a Loop Port Bypass (LPB) to a specific Arbitrated Loop Physical Address(ALPA) or to all ALPAs on the arbitrated loop. [alpa] can be a specific ALPA or thekeyword ALL to choose all ALPAs.clearClears the counters on all ports or the port given by [port_number].enableSends a Loop Port Enable (LPE) to all ALPAs on the arbitrated loop.59245-01 A 12-79