QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

A12 – Command ReferenceSet Config ThresholdSet Config ThresholdSets the port alarm threshold parameters by which the I/O module monitors portperformance and generates alarms. The changes you make with this commandare not retained when you reset or power cycle the I/O module unless you savethem using the Config Save command.AuthoritySyntaxAdmin session and a Config Edit sessionset config thresholdInitiates a configuration session by which to generate and log alarms for selectedevents. The system displays each event, its triggers, and sampling window oneline at a time and prompts you for a value. For each parameter, enter a new valueor press the Enter key to accept the current value shown in brackets. Table 12-15describes the port alarm threshold parameters.Table 12-15. Port Alarm Threshold ParametersParameterThreshold Monitoring EnabledCRCErrorsMonitoringEnabledDecodeErrorsMonitoringEnabledISLMonitoringEnabledLoginMonitoringEnabledLogoutMonitoringEnabledLOSMonitoringEnabledRising TriggerFalling TriggerSample WindowDescriptionMaster enable/disable parameter for all events.Enables (True) or disables (False) the generationof all enabled event alarms. The default is False.The event type enable/disable parameter. Enables(True) or disables (False) the generation of alarmsfor each of the following events:• CRC errors• Decode errors• ISL connection count• Device login errors• Device logout errors• Loss-of-signal errorsThe event count above which a rising trigger alarmis logged. The I/O module will not generateanother rising trigger alarm for that event until thecount descends below the falling trigger and againexceeds the rising trigger.The event count below which a falling trigger alarmis logged. The I/O module will not generateanother falling trigger alarm for that event until thecount exceeds the rising trigger and descendsagain below the falling trigger.The time in seconds in which to count events.59245-01 A 12-71