QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

A12 – Command ReferenceSet Config SwitchSet Config SwitchSets the I/O module configuration parameters. The changes you make with thiscommand are not retained when you reset or power cycle the I/O module unlessyou save them using the Config Save command.AuthoritySyntaxAdmin session and a Config Edit sessionset config switchThis command initiates an editing session in which to change I/O moduleconfiguration settings. The system displays each parameter one line at a time andprompts you for a value. For each parameter, enter a new value or press the Enterkey to accept the current value shown in brackets. Table 12-14 describes the I/Omodule configuration parameters.Table 12-14. I/O Module Configuration ParametersParameterTransparentModeAdminStateSymbolicNameR_A_TOVE_D_TOVConfigDescriptionDescriptionTransparent mode control for the 20-Port Full Fabric Switchthat is in transparent mode.I/O module administrative state.• Online – Activates and prepares the ports to send data.This is the default.• Offline – Prevents the ports from receiving signal andaccepting a device login.• Diagnostics – Prepares the ports for testing and preventsthe ports from accepting a device login.• Down – Disables the ports by removing power from theport lasers.Descriptive name for the I/O module. The name can be up to32 characters excluding #, semicolon (;), and comma (,). Thedefault is QLogic8GbT.Resource Allocation Timeout Value. The number of millisecondsthe I/O module waits to allow two ports to allocateenough resources to establish a link. The default is 10000.Error Detect Timeout Value. The number of milliseconds aport is to wait for errors to clear. The default is 2000.I/O module configuration description. The configurationdescription can be up to 32 characters excluding #, semicolon(;), and comma (,). The default is Default Config.59245-01 A 12-69