QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

A12 – Command ReferenceSet Config PortTable 12-13. Port Configuration Parameters (Continued)ParameterPrimaryTFPortMapBackupTFPortMapDescriptionPrimary mapping for TH_Ports. The mapping consists of a listof TF_Port numbers (delimited by spaces) that are assignedto pass traffic to and from the TH_Port. If you specify N, theTH_Port is unmapped, effectively disconnecting the TH_Portfrom the fabric. The default primary mapping is as follows:• Ports 1, 2 map to port 0• Ports 3, 4 map to port 15• Ports 5–7 map to port 16• Ports 8, 9 map to port 17• Ports 10, 11 map to port 18• Ports 12–14 map to port 19If all TF_Ports in the primary mapping fail, the backup portmapping is used (BackupTFPortMap).When a list is specified, the I/O module distributes the hostNPIV logins across the TF ports in a round-robin fashion forbetter performance.Backup mapping for TH_Ports. The mapping consists of a listof TF_Port numbers (delimited by spaces) that are assignedto pass traffic to and from the TH_Port when all TF_Ports inthe primary mapping (PrimaryTFPortMap) have failed. If youspecify N, the TH_Port is unmapped, effectively disconnectingthe TH_Port from the fabric. The default secondary mappingis as follows:• Ports 1, 2 map to port 15• Ports 3–14 map to port 0When a list is specified, the I/O module distributes the hostNPIV logins across the TF ports in a round-robin fashion forbetter performance.SymbolicPortName Descriptive name for the port. The name can be up to 32characters excluding #, semicolon (;), and comma (,). Thedefault is Port n where n is the port number. This parametercan be changed only with the Set Config Port command.59245-01 A 12-67