QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

A12 – Command ReferenceSet Config PortSet Config PortSets the port configuration parameters for one or more ports. The changes youmake with this command are not retained when you reset or power cycle the I/Omodule unless you save them using the Config Save command.AuthoritySyntaxKeywordsAdmin session and a Config Edit sessionset config port [port_number]orset config portsinternalexternalport [port_number]Initiates an edit session in which to change configuration parameters for the portnumber given by [port_number]. If you omit [port_number], the system begins withport 0 and proceeds in order through the last port. For each parameter, enter anew value or press the Enter key to accept the current value shown in brackets.Enter “q” to end the configuration for one port, or “qq” to end the configuration forall ports. Table 12-13 describes the port configuration parameters.ports [port_set]Initiates an editing session in which to change configuration parameters (exceptsymbolic port name) for the set of all external ports based on external port 0, orthe set of all internal ports based on internal port 1, depending on the value givenby [port_set]. For each parameter, enter a new value or press the Enter key toaccept the current value shown in brackets. Enter “q” to end the configuration.Table 12-13 describes the port configuration parameters. [port_set] can have thefollowing values:externalThe configurations for all external ports (0, 15, 16, 17, 18, 19) are madebased on the configuration of external port 0.internalThe configuration for all internal ports (1–14) are made based on theconfiguration of internal port 1.59245-01 A 12-65