QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

12 – Command ReferenceIpsec PolicySIpsec PolicyManages policies in the Security Policy database.AuthoritySyntaxKeywordsAdmin session and an Ipsec Edit sessionipsec policycopy [policy_source] [policy_destination]create [policy]delete [policy]edit [policy]list [option]rename [policy_old] [policy_new]copy [policy_source] [policy_destination]Creates a new policy named [policy_destination] and copies the configuration intoit from the policy given by [policy_source]. You must enter the Ipsec Savecommand afterwards to save your changes. [policy_destination] must not beginwith DynamicSP_, which is reserved for dynamic policies.create [policy]Creates a policy with the name given by [policy]. A policy name must begin with aletter and be no longer than 32 characters. Valid characters are 0-9, A-Z, a-z, _, $,^, and -. The Security Policy database supports a maximum of 128 user-definedpolicies. You must enter the Ipsec Save command afterwards to save yourchanges. Table 12-3 describes the policy parameters.Table 12-3. Policy Configuration ParametersParameterDescriptionDescriptionSourceAddressDescription of the policyIP address or DNS host name of the host, switch, or gatewayfrom which data originates.SourcePort Source port number (1–65535)DestinationAddressIP address or DNS host name of the host, switch, or gatewayreceiving data. If you specified an IP address for the SourceAddress,the DestinationAddress must use the same IP versionformat.DestinationPort Destination port number (1–65535)12-42 59245-01 A