QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

12 – Command ReferenceImageSunpack [file]Installs the firmware file given by [file]. After unpacking the file, a messageappears confirming successful unpacking. The I/O module must be reset for thenew firmware to take effect.NotesExamplesTo provide consistent performance throughout the fabric, ensure that all switchesare running the same version of firmware.To install firmware when the management workstation has an FTP server, use theImage Install command or the Firmware Install command.The following is an example of the Image Install command:QLogic8GbT #> admin startQLogic8GbT (admin) #> image installWarning: Installing new firmware requires a switch reset.Continuing with this action will terminate all management sessions,including any Telnet sessions. When the firmware activation is complete,you may log in to the switch again.Do you want to continue? [y/n]: yPress 'q' and the ENTER key to abort this command.FTP or TFTP : ftpUser Account : johndoeIP Address : 10.0.0.254Source Filename : 7.10.00.xx_epcAbout to install image. Do you want to continue? [y/n] yConnected to 10.0.0.254 (10.0.0.254).220 localhost.localdomain FTP server (Version wu-2.6.1-18) ready.331 Password required for johndoe.Password: xxxxxxxxx230 User johndoe logged in.bin200 Type set to I.verboseVerbose mode off.This may take several seconds...The switch will now reset.Connection closed by foreign host.12-30 59245-01 A