QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

2 – Command Line Interface UsageEntering CommandsSEntering CommandsThe command-line completion feature makes entering and repeating commandseasier. Table 2-1 describes the command-line completion keystrokes.Table 2-1. Command-Line CompletionKeystrokeTabUp ArrowDown ArrowControl-AControl-EControl-UEffectCompletes the command line. Enter at least one character and pressthe tab key to complete the command line. If more than one possibilityexists, press the Tab key again to display all possibilities.Scrolls backward through the list of previously entered commands.Scrolls forward through the list of previously entered commands.Moves the cursor to the beginning of the command lineMoves the cursor to the end of the command line.Clears the command line.Getting HelpTo display help for a command, enter the Help command followed by thecommand. The following is an example of the help that is available for theConfig Edit command.QLogic8GbT #> help config editconfig edit [CONFIG_NAME]This command initiates a configuration session and places the current sessioninto config edit mode.If CONFIG_NAME is given and it exists, it gets edited; otherwise, it getscreated. If it is not given, the currently active configuration is edited.Admin mode is required for this command.Usage: config edit [CONFIG_NAME]2-4 59245-01 A