QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

12 – Command ReferenceHotresetSHotresetAuthoritySyntaxResets the I/O module for the purpose of activating the pending firmware withoutdisrupting traffic. This command terminates all management sessions, saves allconfiguration information, and clears the event log. After the pending firmware isactivated, the configuration is recovered. This process may take a few minutes. Tosave the event log to a file before resetting, enter the Set Log Archive command.Admin sessionhotresetNotes • You can load and activate version 7.10.x firmware on an operating I/Omodule without disrupting data traffic or having to re-initialize attacheddevices under the following conditions:The current firmware version permits the installation andnon-disruptive activation of 7.10 firmware. Refer to the 7.10 FirmwareRelease Notes for previous compatible firmware versions.No changes are being made to switches in the fabric includinginstalling firmware, powering up, powering down, disconnecting orconnecting ISLs, and switch configuration changes.No port on the I/O module is in the diagnostic state.No changes are being made to attached devices including poweringup, powering down, disconnecting, connecting, and HBA configurationchanges.• Ports that are stable when the non-disruptive activation begins, then changestates, will be reset. When the non-disruptive activation is complete,QuickTools and Enterprise Fabric Suite 2007 sessions reconnectautomatically. However, CLI and SSH sessions must be restarted manually.• This command clears the event log and all counters.12-28 59245-01 A