QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

A12 – Command ReferenceFirmware InstallFirmware InstallDownloads firmware from a remote host to the I/O module, installs the firmware,then resets the I/O module to activate the firmware. This is disruptive. Thecommand prompts you for the following:• The file transfer protocol (FTP or TFTP)• IP address or DNS host name of the remote host• An account name and password on the remote host (FTP only)• Pathname for the firmware image fileAuthoritySyntaxExamplesAdmin sessionfirmware installThe following is an example of the Firmware Install command using FTP:QLogic8GbT #> admin startQLogic8GbT (admin) #> firmware installThe switch will be reset. This process will cause a disruptionto I/O traffic.Continuing with this action will terminate all management sessions,including any Telnet sessions. When the firmware activation is complete,you may log in to the switch again.Do you want to continue? [y/n]: yPress 'q' and the ENTER key to abort this command.FTP or TFTP : ftpUser Account : johndoeIP Address : 10.0.0.254Source Filename : 7.10.00.xx_ipcAbout to install image. Do you want to continue? [y/n] yConnected to 10.0.0.254 (10.0.0.254).220 localhost.localdomain FTP server (Version wu-2.6.1-18) ready.331 Password required for johndoe.Password: xxxxxxxxx230 User johndoe logged in.bin200 Type set to I.verboseVerbose mode off.This may take several seconds...The switch will now reset.Connection closed by foreign host.59245-01 A 12-23