QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

A12 – Command ReferenceDateDateAuthoritySyntaxKeywordsNotesExamplesDisplays or sets the system date and time. To set the date and time theinformation string must be provided in this format: MMDDhhmmCCYY. The newdate and time takes effect immediately.Admin session except to display the date.date[MMDDhhmmCCYY][MMDDhhmmCCYY]Specifies the date – this requires an Admin session. If you omit[MMDDhhmmCCYY], the current date is displayed which does not require anAdmin session.Network Time Protocol (NTP) must be disabled to set the time with the Datecommand. Enter the Set Setup System command to disable theNTPClientEnabled parameter.When setting the date and time on a I/O module that is enabled for SSLconnections, the I/O module time must be within 24 hours of the workstation time.Otherwise, the connection will fail.The following is an example of the Date command:QLogic8GbT #> dateMon Apr 07 07:51:24 200x59245-01 A 12-19